MORE DETAILED VAPING DATA
The clear and precise OLED screen offers an entirely new operation interface. More vaping data for you, such as VW/TC MODE, vaping effect, voltage, battery life, resistance value etc.
Tips: There is a transparent protective layer on this side, you can rip it
SPECIFICATION OF TWO EDITIONS FOR ALIEN MOD
There are A and B two versions of Alien220 mod with the same function as for its improvement of MCU. Edition A will display V1.x.x (newest is V1.2.11) when powered on, while edition B will display VB1.x.x (newest is VB1.0.2). Please make sure the device version and download the corresponding version before firmware upgrading, for A and B version is totally different and cannot be employed universally. (You can brush up the device with the correct version if incorrect version is upgraded, and unmatched firmware upgrading is not recommended as wrong update can result in a brick device,you can flash your VB version Alien by http://www.smoktech.com/support/upgrade/toolsandfirmware/ispalien )
ADJUSTABLE AIRFLOW SYSTEM
Bring you an extremely open draw. Airflow can be adjusted freely by turning the ring at the base of atomizer.
THE KIT INCLUDES
HOW TO BUILD THE RBA
1. Before starting, make sure your hands are clean.
2. Take RBA deck apart.
3. Install and position the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all is in place, make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base.
4. Cut the excess ends of the wire off.
5. Cut a strip of cotton and make sure it’s not too much and not too little.
6. Insert the cotton and placing it in the middle of the coil.
7. Cut the cotton at an angle and make sure it’s not too short and not too long.
8. Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.